Ashtech Z-sensor Specifikace stáhnout pdf (Strana 200)

180 Z-Family Technical Reference Manual

when the pulse was received. This message is not output unless an event pulse is

being input through the appropriate pin of port B and the event marker option (E) is

available in the receiver. This message is therefore independent of the NMEA period

(can be output faster or slower than the NMEA period depending on the period of the

event).

Example: Enable TTT message on port A

$PASHS,NME,TTT,A,ON <enter>

There is no query command for TTT.

$PASHR,TTT

The response message is in the form:

$PASHR,TTT,d1,m2*cc <enter>

Example: $PASHR,TTT,3,18:01:33.1200417 *AC <enter>

UTM: UTM Coordinates

$PASHS,NME,UTM,c,s

This command enables/disables the output of the UTM coordinates on port c, where c

is either A, B, C, or D and s is ON or OFF. If no position is being computed, this

message is not output.

$PASHQ,UTM,c

Query UTM coordinates where c is the optional output serial port. The message is not

output unless position is being computed.

Example: Send UTM message to the current port

$PASHQ,UTM <enter>

Table 6.116: $PASHR,TTT Message Structure

Parameter Description Range

d1 Day of the week. 1: Sunday, 7: Saturday 1 - 7

m2 GPS time tag in hours, minutes and

seconds (hh:mm:ss.sssssss)

0 - 23:59:59.9999999

*cc checksum

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 261 262

Žádné komentáře

Ashtech Z-sensor Specifikace Strana 200